VFD-rated motor cable
Price this when overcurrent or overload faults trace to damaged output wiring.
Lenze SMD Fault 0x0001 — What It Means
Fault 0x0001 on a Lenze SMD drive means the inverter detected overcurrent on the output stage. This usually happens during startup, acceleration, or a sudden load change. The drive trips immediately to protect the IGBTs.
Common Causes
- Acceleration time is too short. The motor demands more current than the drive can deliver during ramp-up.
- Motor or load is mechanically jammed. A stalled load produces very high current instantly.
- Output short or motor winding fault. Damaged motor leads or grounded windings look like overcurrent.
- Motor data is programmed incorrectly. Wrong voltage, frequency, or current values distort control.
- Failed output transistor. If the drive faults instantly with the motor disconnected, suspect internal IGBT damage.
Step-by-Step Fix
- Increase acceleration time in the Lenze parameter menu. If the trip happens during ramp-up, double the accel time first.
- Check the mechanical load. Rotate the shaft by hand with power off. Any binding or jam must be fixed before resetting.
- Disconnect the motor and megger it. Measure each phase to ground. Below 1 MΩ means the motor or cable has an insulation failure.
- Verify motor nameplate parameters in the drive. Voltage, full-load amps, and base frequency must match.
- Check the output stage. If the drive trips with the motor disconnected, the output transistors are likely damaged.
- Test with no load if the application allows. If the fault disappears unloaded, the driven machine is the problem.
Parts Often Needed
| Part | Notes |
|---|---|
| VFD-rated motor cable | Replace damaged output cable |
| Motor | Replace if windings are shorted or grounded |
| Lenze SMD drive | Replace if output stage is failed |
Need Replacement Parts?
Before ordering, match the drive part to the model number, electrical rating, and failure symptom. Check current prices on Amazon - prices and availability change frequently.
When to Call a Pro
If you have correct parameters, a free-turning load, and a clean megger test but 0x0001 still occurs, the drive itself is probably damaged internally.