Tag: dryer

All the articles with the tag "dryer".

• LG Dryer tE3 Error Code - Causes & Fix

  7 Jun, 2026

  tE3 means your LG dryer detected a thermistor (temperature sensor) fault. Most common fix: power-reset the dryer, then replace the thermistor.

• LG Dryer tE2 Error Code - Causes & Fix

  7 Jun, 2026

  tE2 means the thermistor (temperature sensor) is reading out of range. Most often caused by cold air backdraft through the vent in winter.

• LG Dryer tE1 Error Code - Causes & Fix

  7 Jun, 2026

  tE1 means the dryer detected a thermistor fault. Most often a failed sensor or loose connector. Reset power first, then check airflow.

• LG Dryer tE Error Code - Causes & Fix

  7 Jun, 2026

  tE or tE1 means the thermistor temperature sensor has failed or lost signal. Most often the thermistor itself needs replacement.

• LG Dryer PS Error Code - Causes & Fix

  7 Jun, 2026

  PS means improper voltage at the power cord connection. Most often the white and red wires are reversed on the terminal block.

• LG Dryer nP Error Code - Causes & Fix

  7 Jun, 2026

  nP means no current detected at the heater, usually from a tripped breaker or lost 240 V leg. Reset the double-pole breaker fully off 10 sec.

• LG Dryer LE2 Error Code - Causes & Fix

  7 Jun, 2026

  LE2 on LG dryers means a compressor fault on heat-pump models or motor/airflow issues on standard models. Reset power first.

• LG Dryer HS Error Code - Causes & Fix

  7 Jun, 2026

  HS means humidity sensor error. Clean the sensor bars inside the drum below the lint filter, then reset. Most common fix.

• LG Dryer HE Error Code - Causes & Fix

  7 Jun, 2026

  HE on an LG washer-dryer combo means temporary heater error. Power off, unplug, wait, retry. If it repeats, schedule service.

• LG Dryer F0 Error Code - Causes & Fix

  7 Jun, 2026

  F0 means the lint filter is out, not fully seated, or not detected. Reseat the filter firmly and clean the housing to clear the code.

• LG Dryer E4 Error Code - Causes & Fix

  7 Jun, 2026

  E4 is not a standard LG dryer code. Your display likely shows dE4 (door switch fault). Check for obstructions and close the door firmly.

• LG Dryer E13 Error Code - Causes & Fix

  7 Jun, 2026

  E13 on LG hybrid condensing dryers means a condensate drain problem. Most often a kinked or clogged drain hose. Fix by straightening the hose.

• LG Dryer E1 Error Code - Causes & Fix

  7 Jun, 2026

  E1 (tE1) means a thermistor fault. Most often a failed temperature sensor or loose connector. Reset power first, then check sensor.

• LG Dryer E00 Error Code - Causes & Fix

  7 Jun, 2026

  E00 means the display PCB cannot read software from the main control board. Unplug for 60 seconds and restart-if it returns, a board is faulty.

• LG Dryer D95 Error Code - Causes & Fix

  7 Jun, 2026

  D95 means 95% airflow blockage in the exhaust duct. Clean the lint filter and check the outside vent for obstructions or clogs.

• LG Dryer D90 Error Code - Causes & Fix

  7 Jun, 2026

  D90 means 90% duct blockage. Clean the lint filter, check the exterior vent hood for clogs, and inspect the flex hose for kinks.

• LG Dryer D80 Error Code - Causes & Fix

  7 Jun, 2026

  D80 means about 80% airflow restriction in the exhaust vent. Clean the entire vent run from lint screen to exterior hood first.

• LG Dryer D75 Error Code - Causes & Fix

  7 Jun, 2026

  D75 means 75% exhaust blockage. Clean lint from the entire vent run, check for crushed ducts, and verify air blows outside.

• LG Dryer Add Error Code - Causes & Fix

  7 Jun, 2026

  Add means add water to the steam feeder. Fill the drawer to the MAX line with tap water and close it fully. Problem solved in 1 minute.

• Samsung HC4 Dryer Error - Causes & Fix

  7 Jun, 2026

  HC4 means your Samsung dryer is overheating. Clean the lint screen and exhaust vent thoroughly-restricted airflow is the most common cause.

• LG Dryer dE Error Code - Causes & Fix

  7 Jun, 2026

  LG dryer dE means the door is not completely closed. Most often the door latch is not fully engaged or laundry is caught in the seal.

• Frigidaire Dryer E68 Error Code - Causes & Fix

  7 Jun, 2026

  E68 means the dryer detects a stuck button or control-panel fault. Most often it's a sticky button, moisture, or a failed keypad.

• Whirlpool Dryer AF Error Code - Causes & Fix

  7 Jun, 2026

  AF means airflow restriction in the exhaust path. Clean the lint screen and check for kinked or blocked vent ducts first.

• Whirlpool Dryer F22 Error Code - Causes & Fix

  7 Jun, 2026

  F22 means the control can't read the exhaust thermistor. Most often a failed thermistor. Replace it after testing resistance.