Igniter
Price the ignition part only after confirming the model number and connector.
Carrier Error Code 58 — What It Means
Carrier error code 58 indicates a flame sense fault — the flame sensor detected a flame signal when the control board was not in an active ignition sequence, or the flame was sensed but then lost unexpectedly during operation (nuisance flame loss). Code 58 on Carrier furnaces (Comfort, Performance, and Infinity series) protects against gas valve leakage and unstable combustion. Depending on how the fault presents, 58 can indicate a legitimately faulty flame sensor, contaminated sensor, or a gas supply pressure issue causing an unstable flame.
Common Causes
- Dirty or contaminated flame sensor — Carbon buildup on the flame rod is the single most common cause; the sensor can’t efficiently pass ionization current through the coating, causing the control to lose the flame signal.
- Incorrect flame sensor position — If the flame rod is positioned where it only partially intersects the flame, the ionization signal is too weak and intermittent, causing code 58.
- Gas pressure fluctuation — Unstable gas supply pressure causes the flame to flicker or lift off the burner, intermittently breaking the ionization signal during the heating cycle.
- Cracked heat exchanger — A cracked heat exchanger allows excess air into the burner combustion area, diluting the flame and weakening the ionization signal below the detection threshold.
Step-by-Step Fix
- Clean the flame sensor rod — Power off the furnace. Locate the flame sensor (a metal rod extending into the burner flame with a ceramic insulator and a single wire). Remove it (one screw), lightly clean the rod with fine emery cloth or steel wool, and reinstall. This resolves the majority of code 58 faults.
- Inspect the sensor wire and connector — Check the ignition wire from the control board to the flame sensor for damage, loose connection, or melted insulation. A loose connector causes intermittent flame signal loss.
- Check sensor position — Confirm the flame rod is positioned so it extends into the main burner flame. If it’s bent away from the flame, carefully bend it back into the correct position.
- Observe flame stability — Run a heat cycle and watch the burner flames through the observation port (if present) or the burner compartment. A wavering, lifting, or yellow-tipped flame indicates gas pressure or combustion air issues.
- Reset the system — Cycle the breaker to clear code 58 after repairs. If the code returns within one heating cycle, the flame sensor or gas valve requires replacement.
Parts Often Needed
| Part | Notes |
|---|---|
| Flame sensor | Replace when cleaning doesn’t restore a reliable signal |
| Flame sensor wire/harness | Replace if insulation is damaged |
| Gas valve | Replace if unstable flame is confirmed to be from valve pressure variation |
Technician Tips
Carrier uses different diagnostic systems across furnaces, heat pumps, chillers, mini-splits, VRF equipment, rooftop units, and communicating controls. Confirm the full model number and whether the fault came from the indoor board, outdoor board, thermostat, or equipment controller before matching it to a repair path.
Start with power, wiring, airflow or water-flow, sensor, condensate, and safety-circuit checks before ordering control boards. If the same code returns after one reset and the basic cause is not obvious, test the named circuit instead of repeatedly cycling the equipment.
Common replacement parts for Carrier systems:
- Carrier flame sensor (part #HH18ZA641)
- Limit switch kit (part #HH18HA600)
- Pressure switch (part #HH18HA719)
Need Replacement Parts?
Before ordering, match the HVAC part to the model number, electrical rating, and failure symptom. Check current prices on Amazon - prices and availability change frequently.
When to Call a Pro
Code 58 from a cracked heat exchanger is a carbon monoxide hazard. If the flame sensor and gas supply both check out but code 58 persists, have a licensed HVAC tech perform a heat exchanger inspection before operating the furnace further.