Run capacitor
Common no-start and weak-compressor failure point. Match the microfarad and voltage rating.
Burnham Boiler E3 Error Code — What It Means
Burnham boiler error code E3 indicates a high-limit lockout. The high-temperature limit switch or the supply water temperature sensor detected that boiler water temperature exceeded the high-limit setpoint, and the control module has locked out the burner. On Burnham gas boilers (Alpine, ES2, IN series), the high limit is typically factory set at 210°F or 220°F and is adjustable down to a minimum operating setpoint. When the limit trips, the burner shuts off and will not restart until water temperature drops below the reset differential and, on manual-reset limits, a reset is performed. Repeated E3 trips indicate the boiler is consistently overheating during the heating cycle.
Common Causes
- Inadequate system water flow — A closed zone valve, air-bound circuit, failed circulator pump, or closed isolation valve restricts flow through the boiler. Without flow, heat builds in the boiler water rapidly and the high limit trips.
- High limit setpoint too low — If the high-limit was adjusted below the normal operating range or the boiler is on a high-mass radiant system that requires higher temperatures, the limit setpoint may need adjustment.
- Failed or short-cycling circulator — The circulator pump runs intermittently or at reduced flow due to a failed pump, seized bearing, or air lock. Inadequate flow causes localized overheating in the boiler sections.
- Oversized boiler or short cycling on small load — An oversized boiler firing at full input on a small radiation load can ramp up boiler water temperature faster than the radiation can absorb it, causing the limit to trip before the thermostat is satisfied.
Step-by-Step Fix
- Check all zone valves and isolation valves — Confirm every zone valve in the system is in the open or auto position. Verify ball valves on the supply and return piping are fully open. A single closed zone on a small system can restrict flow enough to trip the limit.
- Verify circulator operation — With the boiler firing, confirm the circulator is running (feel for vibration at the pump body or check amp draw). A running pump with no flow indicates an air lock; bleed air from the high points of the system.
- Check system pressure — Boiler operating pressure should be 12–15 psi (residential systems). Low pressure (below 10 psi) indicates a water loss or waterlogged expansion tank that won’t maintain system pressure.
- Reset the high-limit switch — On manual-reset Burnham units, locate the red or white reset button on the limit control (usually on the supply manifold). Allow the boiler to cool, then press the reset firmly.
- Review high-limit setpoint — Confirm the high-limit is set appropriately (180–200°F for most baseboard systems; 140–160°F for radiant floor). Do not raise the setpoint above manufacturer limits.
Parts Often Needed
| Part | Notes |
|---|---|
| Circulator pump | Replace if failed; Taco 007 or Grundfos 15-58 are common on Burnham systems |
| Expansion tank | Replace if waterlogged (tap the tank — a full-water sound means replace) |
| High-limit control | Replace if it won’t reset or trips below setpoint |
Need Replacement Parts?
Before ordering, match the water-heating part to the model number, electrical rating, and failure symptom. Check current prices on Amazon - prices and availability change frequently.
When to Call a Pro
If the circulator is running, all valves are open, and the system still trips E3, there may be a hydraulic balancing issue, a failed heat exchanger, or significant scale buildup inside the boiler sections. A licensed boiler technician can perform a combustion test and flow measurement to identify the root cause.