Posts

All the articles I've posted.

• KitchenAid CAL Error Code - Causes & Fix

  9 Jun, 2026

  CAL is not an error code. It means your KitchenAid oven is in calibration mode. Exit the menu or adjust the temperature offset per your manual.

• KitchenAid FAE5 Error Code - Causes & Fix

  9 Jun, 2026

  FAE5 means water has leaked under your dishwasher, triggering the flood sensor. Most often caused by excessive suds from wrong detergent.

• KitchenAid Dishwasher F6E3 Error - Causes & Fix

  9 Jun, 2026

  F6E3 means foam or suds detected in the tub. Most common fix: remove suds, add 2-3 tbsp cooking oil, run empty cycle with no detergent.

• Frigidaire Dryer AL-22 Error Code - Causes & Fix

  9 Jun, 2026

  AL-22 is not a standard Frigidaire code. Most likely the display was misread or the model uses a non-standard format. Reset power first.

• Maytag F74 Error Code - Causes & Fix

  9 Jun, 2026

  F74 means the user interface board has a memory fault. The most common fix is replacing the UI control board after a power reset fails.

• KitchenAid F7E2 Error Code - Causes & Fix

  9 Jun, 2026

  F7E2 means the control detected a wash motor fault. Most common fix: replace the circulation motor after a power reset fails to clear it.

• KitchenAid F3E2 Error Code - Causes & Fix

  9 Jun, 2026

  F3E2 means oven temperature sensor fault. The most common fix is replacing the faulty sensor or repairing its wiring harness.

• KitchenAid F1E2 Dishwasher Error - Causes & Fix

  9 Jun, 2026

  F1E2 means a defective or incompatible electronic control board. Power-cycle the dishwasher for 5 minutes; if the code returns, replace the board.

• KitchenAid F1E1 Error - Causes & Fix

  9 Jun, 2026

  F1E1 means a control board relay fault. The dishwasher drains then stops. Most often a stuck relay on the electronic control board.

• Bosch Washer F42 Error Code - Causes & Fix

  9 Jun, 2026

  F42 means motor overspeed detected. Most often a faulty tacho sensor or worn carbon brushes cause erratic motor feedback.

• Bosch Washer F40 Error Code - Causes & Fix

  9 Jun, 2026

  F40 means no power or voltage too low at the washer. Check the wall outlet, reset the breaker, and plug directly into a working outlet.

• Bosch Washer F28 Error Code - Causes & Fix

  9 Jun, 2026

  F28 means the flow sensor is faulty or not detecting water entering the machine. The most common fix is replacing the flow sensor.

• Bosch F27 Error Code - Causes & Fix

  9 Jun, 2026

  F27 means a faulty pressure sensor or pressure-sensing circuit. The most common fix is replacing the pressure switch or clearing the tube.

• Bosch Washer F26 Error Code - Causes & Fix

  9 Jun, 2026

  F26 means the analogue pressure sensor cannot report water level. Bosch says this fault is not user-repairable and requires service.

• Bosch Washer F23 Error Code - Causes & Fix

  9 Jun, 2026

  F23 means the AquaStop leak-protection system detected water in the base pan. Most often caused by a damaged inlet or drain hose.

• Bosch Washer F20 Error Code - Causes & Fix

  9 Jun, 2026

  F20 means unexpected heating: water is heating when it shouldn't. Most often the NTC temperature sensor or heater relay has failed.

• Bosch E32 Error Code - Causes & Fix

  9 Jun, 2026

  E32 means the load is unbalanced and the spin cycle stopped. Redistribute laundry evenly in the drum and restart the spin cycle.

• Bosch Washer E29 Error Code - Causes & Fix

  9 Jun, 2026

  E29 means your Bosch washer detects insufficient water fill. Most common fix: clean the inlet filter screen at the hose connection.

• Bosch Washer E28 Error Code - Causes & Fix

  9 Jun, 2026

  E28/F28 means the washer's flow sensor is not seeing expected water flow during fill. Most often a failed flow sensor or blocked inlet.

• Bosch Washer E20 Error Code - Causes & Fix

  9 Jun, 2026

  E20 on a Bosch washer signals unexpected heating. Turn the washer off, wait 30 seconds, and turn it back on to reset the fault.

• Bosch Dishwasher E03 Error Code - Causes & Fix

  9 Jun, 2026

  E03 on a Bosch dishwasher usually signals a control-board relay fault or water inlet problem. Most often the main control board relay has failed.

• Frigidaire Dryer AL-02 Error Code - Causes & Fix

  9 Jun, 2026

  AL-02 is not a standard Frigidaire dryer code. First verify the exact display and model, then perform a hard reset by unplugging for 5 minutes.

• Bosch E24 Error Code - Causes & Fix

  9 Jun, 2026

  E24 means your Bosch dishwasher won't drain. Most often caused by a blocked drain filter. Clean the filter under the spray arm first.

• Amana Dryer Loud Banging - Causes & Fix

  9 Jun, 2026

  Loose items in the drum or worn drum rollers are the most common causes. Remove coins, buttons, or pins, then check rollers for wear.