Tag: symptom
All the articles with the tag "symptom".
-
Kenmore Washer Won't Agitate - Causes & Fix
Most often worn agitator dogs inside the upper agitator assembly. Remove the cap and bolt, inspect the dogs for rounding or wear, and replace them.
-
Kenmore Washer Burning Smell - Causes & Fix
Usually a slipping or worn drive belt overheating under load. Unplug immediately, inspect the belt for glazing or damage, and replace it.
-
Kenmore Washer Not Draining Completely - Causes & Fix
Usually a clogged drain pump filter or kinked drain hose. Clean the pump trap and check the hose for blockages or kinks.
-
Frigidaire Washer Stuck on One Cycle - Causes & Fix
Usually a faulty lid switch or door lock prevents spin, or the pressure hose is clogged and the control never sees correct water level.
-
Frigidaire Washer Not Dispensing Detergent - Causes & Fix
Usually caused by detergent buildup clogging the drawer, siphon tubes, or spray holes. Pull the drawer, clean all residue, and check water flow.
-
Frigidaire Washer Overflowing - Causes & Fix
Most often caused by a stuck-open water inlet valve or failed pressure switch that can't stop the fill cycle correctly.
-
Frigidaire Washer Smells Like Mildew - Causes & Fix
Usually caused by trapped moisture and detergent residue in the drum, gasket, or drain. Clean all surfaces, run a hot cycle, and leave the door open after use.
-
Frigidaire Washer Won't Agitate - Causes & Fix
Worn agitator dogs or a failed drive coupler usually stop agitation. Replace the agitator repair kit or coupler to restore wash action.
-
Frigidaire Washer Burning Smell - Causes & Fix
Usually caused by a slipping or glazed drive belt overheating from friction. Unplug, inspect the belt for glazing or cracks, and replace if damaged.
-
Frigidaire Washer Not Draining Completely - Causes & Fix
Usually a kinked drain hose or clogged pump filter. Check the hose routing, clear the coin trap, and test the drain pump.
-
GE Washer Stuck on One Cycle - Causes & Fix
Usually caused by electronic control lockup after a power or cycle interruption. Unplug for 2 minutes, restore power, and reselect the cycle.
-
GE Washer Not Dispensing Detergent - Causes & Fix
Usually a clogged dispenser drawer from detergent residue. Remove the drawer, wash it in warm soapy water, and check siphon caps are seated.
-
GE Washer Overflowing - Causes & Fix
A GE washer overflowing usually means a failed water inlet valve that won't close or a clogged pressure hose preventing level detection.
-
GE Washer Smells Like Mildew - Causes & Fix
Usually detergent residue buildup in the tub, dispenser, or gasket folds. Run a hot tub-clean cycle with bleach and wipe the gasket dry.
-
GE Washer Won't Agitate - Causes & Fix
A worn or slipping drive belt is the most common cause. Enter diagnostic mode to retrieve fault codes, then inspect the belt and pulleys for wear or blockage.
-
GE Washer Burning Smell - Causes & Fix
Usually a slipping drive belt, seized drain pump, or rubbing door gasket. Stop the washer, check the belt and pump for drag, and replace the worn part.
-
GE Washer Not Draining Completely - Causes & Fix
Most often a kinked or clogged drain hose or a failed drain pump. Check the hose first, then test pump power and resistance.
-
Maytag Washer Stuck on One Cycle - Causes & Fix
Usually caused by drain blockage, unbalanced load, or lid switch issue. Check drain hose for kinks, redistribute load, and verify lid closure.
-
Maytag Washer Not Dispensing Detergent - Causes & Fix
Usually a clogged dispenser drawer or tray blocking water flow. Remove the drawer, clean all residue, and check that the washer is level.
-
Maytag Washer Overflowing - Causes & Fix
A Maytag washer overflowing is usually caused by a stuck or leaking water inlet valve that won't shut off, or a clogged pressure switch tube.
-
Maytag Washer Smells Like Mildew - Causes & Fix
Wet laundry left inside and a closed door prevent drying, leading to mildew buildup. Remove loads promptly, leave the door open, and run a Clean Washer cycle with hot water.
-
Maytag Washer Won't Agitate - Causes & Fix
Usually a failed shift actuator that can't move the drive into agitate mode. Check actuator engagement, then test belt and motor.
-
Maytag Washer Burning Smell - Causes & Fix
Usually a slipping or worn drive belt on a seized pump or damaged pulley. Unplug, inspect belt and pulleys, and replace worn parts.
-
Maytag Washer Not Draining Completely - Causes & Fix
Usually a kinked or clogged drain hose. Check hose routing and standpipe depth, then inspect the pump for debris or blockage.