Tag: appliance
All the articles with the tag "appliance".
-
Frigidaire Dryer Takes Too Long to Dry - Causes & Fix
Most Frigidaire dryers take too long to dry because of a clogged lint screen or blocked exhaust vent. Clean both and check your cycle setting.
-
Frigidaire Dryer Won't Start - Causes & Fix
Usually a door-switch issue. Check that the door latches fully and test the door switch for continuity when closed.
-
Frigidaire Dryer Not Heating - Causes & Fix
A blown thermal fuse or open heating element is the most common cause. Check power supply and airflow before replacing parts.
-
Kenmore Dryer Gets Too Hot - Causes & Fix
Usually caused by a blocked exhaust vent or lint screen. Clean the full vent path and lint trap, then check the thermistor and heater circuit.
-
Kenmore Dryer Won't Stop - Causes & Fix
Usually a failed timer or control board keeping the motor circuit closed. Reset the control by unplugging for five minutes, then replace the defective timer or board if the symptom returns.
-
Kenmore Dryer Loud Banging - Causes & Fix
Worn drum support rollers are the most common cause. Unplug the unit, remove access panels, and inspect rollers for flat spots or wobble.
-
Kenmore Dryer Clothes Still Damp - Causes & Fix
Most often caused by a clogged lint screen or restricted exhaust vent. Clean the filter and inspect the entire vent path for kinks or blockages.
-
Kenmore Dryer Burning Smell - Causes & Fix
Usually lint buildup in the screen, blower, or vent hose overheating. Clean the lint screen and entire vent system, then test empty.
-
GE Dryer Gets Too Hot - Causes & Fix
A shorted heating element is the most common cause. Disconnect power, test element resistance to ground, and replace if shorted.
-
GE Dryer Won't Stop Running - Causes & Fix
Most likely a stuck heater relay on the main control board. Unplug immediately if it keeps heating after cycle ends to prevent fire risk.
-
GE Dryer Loud Banging - Causes & Fix
Worn drum support rollers are the most common cause. Unplug, spin the drum by hand, and replace any worn rollers or glides.
-
GE Dryer Clothes Still Damp - Causes & Fix
Damp clothes at cycle end usually mean poor wash spin left excess water, blocked drain, or kinked vent. Balance the load and check airflow first.
-
GE Dryer Burning Smell - Causes & Fix
Usually caused by lint buildup near the heater or in the vent system. Clean the lint path, vent, and heater housing first.
-
Maytag Dryer Gets Too Hot - Causes & Fix
Usually caused by a blocked vent or lint buildup restricting airflow. Clean the lint screen, vent hose, and exterior hood first.
-
Maytag Dryer Won't Stop - Causes & Fix
Usually a stuck start button or faulty user interface board sending continuous run signals. Reset power and inspect console buttons first.
-
Maytag Dryer Loud Banging - Causes & Fix
Usually caused by an unbalanced load or bulky items bunching up in the drum. Redistribute the load and run a test cycle to confirm.
-
Maytag Dryer Clothes Still Damp - Causes & Fix
Restricted airflow from clogged lint screens, blocked vents, or crushed ducting is the most common cause. Clean the full exhaust path first.
-
Maytag Dryer Burning Smell - Causes & Fix
Lint buildup in the trap, housing, or vent is the most common cause. Unplug, clean all lint paths, and inspect airflow before parts.
-
Whirlpool Dryer Won't Stop - Causes & Fix
Most often caused by a stuck control board relay or restricted airflow. Check for AF/F4E3 code, power reset the dryer, and inspect the vent.
-
Whirlpool Dryer Gets Too Hot - Causes & Fix
Blocked venting is the most common cause. Clean the lint screen, check the exhaust duct for kinks or clogs, and test airflow with vent disconnected.
-
Whirlpool Dryer Clothes Still Damp - Causes & Fix
Clogged lint screen or exhaust vent restricts airflow. Clean the lint filter and check the vent duct for kinks or blockages.
-
Whirlpool Dryer Loud Banging - Causes & Fix
Usually worn drum support rollers or loose items in the drum. Inspect rollers for flat spots and check drum interior for debris.
-
LG Dryer Won't Stop - Causes & Fix
Usually a faulty door switch or stuck control-board relay. Test the door-latch mechanism, then reset the control and check the switch circuit.
-
Whirlpool Dryer Burning Smell - Causes & Fix
Lint buildup near the heater or exhaust is the most common cause. Unplug, clean the lint screen, chute, and vent hose completely, then test.