What does Samsung Dishwasher bE Error Code - Causes & Fix mean?

bE means a button is stuck on the control panel. Clean the buttons first, then replace the panel or membrane if one stays pressed.

How do I fix Samsung Dishwasher bE Error Code - Causes & Fix?

Follow the step-by-step diagnosis below. The most likely fix is identified by checking power, sensor resistance, and control-board signals in order — using a multimeter and the part numbers documented in the parts reference table.

Can I keep running the equipment with this fault active?

Generally no. Faults on Appliance units are emitted when a sensor, safety, or control circuit is outside its operating envelope. Running through an active fault risks compressor, heater, or control-board damage. Diagnose and clear the fault first.

What part is most commonly replaced for Samsung Dishwasher bE Error Code - Causes & Fix?

The most frequently replaced parts for Samsung Dishwasher bE Error Code - Causes & Fix are listed in the Parts Reference section of this guide with OEM part numbers and typical price ranges. Check the table for direct replacements.

Is Samsung Dishwasher bE Error Code - Causes & Fix a DIY repair or do I need a technician?

Sensor swaps, fan motor replacements, and condenser cleaning are typical DIY-level repairs. Anything involving refrigerant, gas, or high-voltage (>240V) work requires a licensed technician for both safety and code-compliance reasons.

Samsung Dishwasher bE Error Code - Causes & Fix

Samsung Dishwasher bE Error Code — What It Means

The bE code (shown as 6E on some models) means the control detects a button held down, or stuck, on the panel. The dishwasher reads a continuous press it never gets released.

This is usually a sticky or swollen button on the touch panel rather than a deeper electrical fault.

Jump to Fix

Common Causes

Stuck or sticky button Spilled food or residue holds a button down so the control reads it as pressed.
Swollen button membrane Heat and moisture warp the membrane so a key stays engaged.
Trapped debris under a key Crumbs or grime under a button keep the contact closed.
Moisture in the panel Steam or water behind the panel bridges a contact and mimics a press.
Failed touch panel or board A bad control panel or membrane keeps sending the stuck signal.
Damaged ribbon connector A pinched or corroded panel ribbon shorts a button line.

Step-by-Step Fix

Hold Start or Cancel for about 3 seconds to try a reset, then watch for the code to clear.
If it returns, disconnect power and wipe the control panel and every button clean.
Press each button in turn to feel for one that sticks or does not spring back.
Let the panel dry fully if there is any sign of moisture behind it.
Restore power and run a cycle to see if bE stays gone.
If a single button keeps sticking, plan to replace the touch panel or membrane.
Check the panel ribbon connector for pinching or corrosion before fitting a new panel.

Parts Often Needed

Part	Notes
Samsung dishwasher control panel	Amazon \| Match the panel to your exact model, since button layout varies.
Touch button membrane	Amazon \| Only if your model offers the membrane as a separate part.
Panel ribbon connector	Amazon \| Replace if the ribbon is pinched or corroded at the board.

When to Call a Pro

If cleaning and drying do not free the stuck button and a new panel does not clear bE, the main control board may be reading the fault. A technician can confirm whether the panel or board is at fault before another swap.