What does Maytag Washer LC Error Code - Causes & Fix mean?

LC or LoC means Control Lock is activated, not a failure. Press and hold the Control Lock button for 3–5 seconds to clear the code.

How do I fix Maytag Washer LC Error Code - Causes & Fix?

Follow the step-by-step diagnosis below. The most likely fix is identified by checking power, sensor resistance, and control-board signals in order — using a multimeter and the part numbers documented in the parts reference table.

Can I keep running the equipment with this fault active?

Generally no. Faults on Appliance units are emitted when a sensor, safety, or control circuit is outside its operating envelope. Running through an active fault risks compressor, heater, or control-board damage. Diagnose and clear the fault first.

What part is most commonly replaced for Maytag Washer LC Error Code - Causes & Fix?

The most frequently replaced parts for Maytag Washer LC Error Code - Causes & Fix are listed in the Parts Reference section of this guide with OEM part numbers and typical price ranges. Check the table for direct replacements.

Is Maytag Washer LC Error Code - Causes & Fix a DIY repair or do I need a technician?

Sensor swaps, fan motor replacements, and condenser cleaning are typical DIY-level repairs. Anything involving refrigerant, gas, or high-voltage (>240V) work requires a licensed technician for both safety and code-compliance reasons.

Maytag Washer LC Error Code - Causes & Fix

Maytag Washer LC Error Code — What It Means

The LC (or LoC / LOC) code on your Maytag washer indicates that the Control Lock feature has been activated. This is not a failure code. It simply means the user interface is locked so cycle settings cannot be changed accidentally during operation. The washer itself is functioning normally, but the control panel will not respond to button presses until you deactivate the lock.

Jump to Fix

Common Causes

Control Lock button pressed Someone pressed and held the Control Lock function, either intentionally or by accident.
Secondary function activated On some models, a secondary button function or key combination enabled the lock without using a dedicated Control Lock button.
Touchpad membrane issue A stuck or damaged key membrane can register a continuous Control Lock input even when you are not pressing the button.
Control panel harness fault A loose or corroded harness connection between the control panel and main board can cause erratic lock signals.

Step-by-Step Fix

Locate the Control Lock button on your control panel or find the key with a lock/key symbol printed as a secondary function above or below another button.
Press and hold the Control Lock button for 3 to 5 seconds until the LC code or lock icon disappears from the display.
Check your owner’s manual if the code does not clear, since some older models use a different button combination to disable the lock.
Unplug the washer or turn off the circuit breaker for about 5 minutes if the lock still does not release, then restore power and try the Control Lock button again.
Inspect the control panel for visible damage, stuck buttons, or moisture around the touchpad if the LC code returns immediately after clearing.
Test the key response by pressing each button gently to confirm that all keys release properly and none are physically stuck.
Replace the user interface or touchpad assembly if the LC code persists after a power reset and no mechanical button issues are found, as the input circuit is likely faulty.

Parts Often Needed

Part	Notes
Control Panel / User Interface Assembly	Amazon \| Required if the Control Lock signal cannot be cleared by normal input or power reset and the touchpad or membrane is faulty.
Console / Touchpad Membrane	Amazon \| Order the membrane kit specific to your model if only the key surface is damaged or unresponsive.

When to Call a Pro

Call a technician if the LC code does not clear after you hold the Control Lock button and perform a full 5-minute power reset. If the code reappears immediately every time you restore power, or if other buttons on the control panel are also unresponsive, the user interface board or its wiring harness likely needs diagnosis with a multimeter and possible replacement. A qualified service tech can verify the correct part number for your specific Maytag model and test the control board signals before ordering components.