LG Dryer dE Error Code — What It Means
dE is a door error. The dryer senses that the door is open or not fully latched, so it will not start or it stops mid cycle.
Sometimes it is just a stuck filter or a bit of laundry caught in the door, but a repeat code usually points to the door switch or latch.
Common Causes
- Worn door switch The switch that confirms the door is shut wears out and no longer makes contact.
- Broken door latch A cracked latch or strike keeps the door from pressing the switch fully.
- Misaligned door Loose hinges let the door sag so the latch never lines up with the switch.
- Obstruction at the door A lint filter that is not seated or laundry caught in the seal holds the door open.
- Damaged wiring A broken wire or loose connector between the switch and the board breaks the signal.
Step-by-Step Fix
- Reseat the lint filter and push it all the way down into its slot.
- Close the door firmly and check that no laundry is caught in the seal.
- Power cycle the dryer by unplugging it for one minute, then try a cycle again.
- Inspect the latch and strike for cracks and confirm the door clicks shut.
- Unplug and remove the front panel to reach the door switch behind the opening.
- Test the door switch for continuity as you press it, and replace it if it does not switch.
- Reassemble and start a cycle to confirm the dryer runs with the door closed.
Parts Often Needed
| Part | Notes |
|---|---|
| LG dryer door switch assembly | Amazon | Part 6601EL3001A fits many LG and Kenmore models, but confirm against your model. |
| LG dryer door latch | Amazon | Replace if the latch or strike is cracked or worn. |
| LG dryer door hinge | Amazon | Only needed if the door sags and throws off the latch alignment. |
When to Call a Pro
Most dE repairs are within reach for a confident DIYer. If the switch and latch both test good and the door is aligned but dE keeps coming back, the wiring or control board may be at fault, and that is a good time to call an appliance pro.